, it mentions
3 options to start/stop the profiler. Are these what you need?
5. Start the profiler in CeLog mode. When the profiler starts, it will
change the CeLog zone settings to prevent other non-profiling events from
being stored in the log.
Option 1: Type "prof on -l" in the Target Control Window, to start profiling
in CeLog mode.
Option 2: Hit the F8 key until the profiler is toggled to CeLog mode. The
current output mode will be printed to debug output. Hitting this key does
not start the profiler. Start the Monte Carlo profiler by hitting the F9 key.
Option 3: Control the profiler from an application using the ProfileStart
API. Make sure to use the new PROFILE_CELOG flag with ProfileStart.
6. Run your test application.
7. Stop the profiler. You will get some debug output, but the profiler data
is in the CeLog stream, so you won't see profiler results in the debug
output. When the profiler stops, it will restore the original CeLog zone
settings that were active before profiling was started.
Option 1: Type "prof off" in the Target Control window.
Option 2: Hit the F12 key to stop the profiler.
Option 3: Stop the profiler from within an application by using the