The Jackass Blog with The Babble of Jon Banquer

The Jackass Blog with The Babble of Jon Banquer

Post by Clif » Sun, 13 Dec 2009 18:28:32

 
 
 

1. Two New Pages Added To The Jon Banquer Blog

2. The Jon Banquer Blog Will Cover Siemens NX

NX is arguably one of the most powerful CADCAM programs in the world.
I recently had a non-canned demo of NX done by someone who flew in to
demonstrate what I wanted to see. NX is so powerful and so advanced
that after hours only a very small part of what this program can do
had been shown. The unfortunate part of a program being this powerful
is that no one, including Siemens, has ever been able to properly
describe to a Gibbscam, Mastercam, Featurecam, Surfcam, etc. users
what NX can really do in detail and why NX is so much better and so
much more advanced.

In the coming months the Jon Banquer blog will again break new ground
and attempt to do what no one so far has ever been able to do... show
how the power of NX can make a major difference in shops that are
currently using the products I mentioned above.

Shops that are similar to ours, like Apple's prototype shop, have used
NX for years. There is a reason why and I'll do my best to explain
why.

Jon Banquer
San Diego, CA
http://www.yqcomputer.com/

3. Third Jon Banquer Blog Setup

4. Coming This Weekend To The Jon Banquer Blog

5. For Those Who Rely On The Jon Banquer Blog...

6. Go Daddy Seeking To Host Jon Banquer's New Blog?

7. New This Weekend On The Jon Banquer Blog

8. Quad-I Vise Vise Review Coming Soon To The Jon Banquer Blog

9. Jon Banquer Blog Updated

10. The Jon Banquer Blog Is Getting A Face Lift

11. Go Daddy Seeking To Host Jon Banquer's New Blog?

12. If You're Not Reading Jon Banquer Blog You're a wise guy

13. Jon Banquer Blog Updated Today!

14. A: Liars_Blog Q: What is the Jon Banquer Blog AKA?

15. The Jon Banquer Blog Now Has...