MTA TCP/IP Transport stack

MTA TCP/IP Transport stack

Post by Rich Wilso » Fri, 22 Aug 2003 21:55:48


HI,

I want to set up a new MTA TCP/IP transport stack for use
with X.400, however when I right click the X.400 service
node the option for this is missing. Any help would be
greatly appreciated.

Thanks

Richard
 
 
 

1. Packets from bottom of TCP/IP stack direct to application bypassing stack

2. Packets from bottom of TCP/IP stack direct to application by passing stack

Hello Everyone

I am working on a ADSL modem and have the following situation that I
would like to have some advice on.

I need to filter out some packages in the lower level of the network
stack. There are 2 types of packages: [eth | ppp | ip | udp] and [eth
| ip | udp], the data in these packages are the same and they can be
identified with the first 16 bits in the UDP data.

I have manage to catch these packages in the /net/core/dev.c file and
function netif_rx(...) with the 16 bit ID so I have the packages.

Now for my question: How do I in an easy way get these packages
directly to my application without using the network stack. I need
BOTH of these packages to reach there and if I use socket the one with
PPP get thrown away somewhere and that is not so good.

I know this is not a very specific question and a little vague but
some advice and pointers would be appreciated.

Regards
Andreas

3. VxWorks TCP/IP Stack and incoming TCP connections

4. IP broken? (actually, transport lost but stack operational?)

5. Help connecting to CE device using TCP/IP transport/manual server

6. tcp/ip network transport

7. tcp/ip network transport not installed

8. TCP/IP Network Transport not install

9. TCP/IP Transport not installed

10. TCP/IP Networt Transport

11. TCP/IP network transport not installed