I'm trying to plot the location of a well, stagnation points, etc..

with my contour lines of potential and streamlines using fcontour2d.

I'd like to just have an asterisk or other marker on the contour plot.

Does anyone know how to do this?

1. How can contour plot without any contour lines?

I found out that Proc Gcontour can produce the contour

plot of Z=f(x,y). Normally, the contour plot is

superimposed on the plot of points of Y vs X. Can you

tell me how to create these two plots at the same

time?

Thank you

Dale

proc gcontour data=a;

plot y*x=z;

run;quit;

__________________________________________________

Do You Yahoo!?

Tired of spam? Yahoo! Mail has the best spam protection around

http://www.yqcomputer.com/

3. Plotting 3D points on 2D-contour plots with colors indicating z values

4. plotting points over contour plot / graph transparency

5. How to plot contour with contour lines data

6. Removing Plot lines between plot points on a line chart

7. Contour Plot / Plot Range / Contour Scaling

8. plotting a 2D line on top of a contour plot

9. plotting max value line on a contour plot

10. Label plot lines like a contour plot

11. merge contour plots and line plots

12. Using ListPlot to Plot Lines and Single Points

13. plotting data with specific colors / plotting a single point

14. Can I plot a single point on a fcontour2d plot?

15. Plot contour plots on 2D planes of 3D plot

1 post • Page:**1** of **1**