Adding IDE hard drive on 2nd IDE channel

Adding IDE hard drive on 2nd IDE channel

Post by Gary Quiri » Fri, 20 Feb 2004 09:26:35


I have a GigaByte KT400 M/B where the primary drive and CD-ROM are on
the first IDE controller. I would like to add a 2nd hard drive to the
other ob-board controller (master). When I run mkdev hd and select
add hard disk to IDE controller I get the following:

Ctrl Num 0, Drive 1: No such device.

I am using SCO 5.0.6. Output from /var/adm/messages:

%kernel - - - rel=3.2v5.0.6 kid=2000-07-27
%cpu - - - unit=1 family=6 type=AMD gtAthlon
%cpuid - - - unit=1 vend=AuthenticAMD tfms=0:6:8:1
%amd - - - unit=1 family=7 model=8 step=1
%fpu - 13 - unit=1 type=80387-compatible
%pci 0x0CF8-0x0CFF - - am=1 sc=1 buses=2
%PnP - - - nodes=0
%clock - - - type=TSC/2009318296Hz
%serial 0x03F8-0x03FF 4 - unit=0 type=Standard nports=1 fifo=yes
%serial 0x02F8-0x02FF 3 - unit=1 type=Standard nports=1 fifo=yes
%console - - - unit=vga type=0 num=12 scoansi=1 scroll=50
%adapter 0xD000-0xD0FF 11 - type=alad ha=0 bus=0 id=7 fts=sto
%floppy 0x03F2-0x03F7 6 2 unit=0 type=135ds18
%adapter 0x01F0-0x01F7 14 - type=IDE ctlr=primary dvr=wd
%eeE0 0xD400-0xD41F 10 - type=EE PRO/100+ 00:a0:c9:d5:e1:ae
%cd-rom - - - type=IDE ctlr=pri cfg=slvdvr=Srom->wd
%tape - - - type=S ha=0 id=3 lun=0 bus=0 ht=alad
%disk 0x01F0-0x01F7 14 - type=W0 unit=0 cyls=2491 hds=255
secs=63
mem: total = 1048124k, kernel = 129452k, user = 918672k
swapdev = 1/41, swplo = 0, nswap = 978944, swapmem = 489472k
Autoboot from rootdev = 1/42, pipedev = 1/42, dumpdev = 1/41
kernel: Hz = 100, i/o bufs = 104492k (high bufs = 103468k)


Thanks
Gary Quiring
 
 
 

Adding IDE hard drive on 2nd IDE channel

Post by Gary Quiri » Fri, 20 Feb 2004 09:46:40

On Wed, 18 Feb 2004 19:26:35 -0500, Gary Quiring < XXXX@XXXXX.COM >


Ok I got it. mkdev hd 0 1, forget the interactive mode.

GQ