[2.4.25] hdb: dma-timer-expiry: dma status=0x61, error waiting for DMA

[2.4.25] hdb: dma-timer-expiry: dma status=0x61, error waiting for DMA

Post by Jin Su » Thu, 26 Feb 2004 06:20:07


Hello,

I recently upgraded my kernel to 2.4.25 on Dell 530 dual Xeons/2gb RAM. I had
the following error twice.

hdb: dma-timer-expiry: dma status=0x61
hdb: error waiting for DMA

Then the system gets hung. It happens in the morning when I hit the enter key
at the command prompt to refresh my system. Did I set the wrong DMA in the
kernel configuration? I enabled the followings:

Generic PCI bus-master DMA support
Use PCI DMA by default when available

Could someone help me?

Thanks,
Jin


__________________________________
Do you Yahoo!?
Yahoo! Mail SpamGuard - Read only the mail you want.
http://www.yqcomputer.com/
-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to XXXX@XXXXX.COM
More majordomo info at http://www.yqcomputer.com/
Please read the FAQ at http://www.yqcomputer.com/
 
 
 

1. NEW crash - DMA disabled - lost interrupt - timeout waiting for DMA - ??

2. Hard Drive Showing as Ultra DMA Mode 3 instead of Ultra DMA Mo

Here is some of the info I found:
1. In BIOS for Oboard IDE 1- Controler is "Enabled", Master Drive PIO Mode
"Auto", Select Drive PIO Mode "Auto", Master Drive Ultra DMA "Auto", Slave
Drive Ultra DMA "Auto"

2. In BIOS Access Mode "Auto"

3. In Device Manager in the Primary IDE Channel Properties, Device 0 is
"Auto Detection" and Device 1 is "Auto Detection." Do you think I should put
this to 'None" or is "Auto Detection" fine.

Appreciate your suggestions, and what else I might look into to solve this
problem.

THANKS

3. Help requested with DMA 2 and DMA 5

4. [PATCH 1/5] dma: add dma_flags_set_attr() to dma interface

5. DMA mapping (was [PATCH] cciss 2.6; replaces DMA masks with kernel defines)

6. [1/4] dma: add dma_flags_set_dmabarrier() to dma interface

7. What's better: ATA/33 w DMA or ATA/66 w/o DMA ?

8. XP DMA PROBLEM, UNABLE TO CHANGE TO DMA

9. [RFC 4/7][PATCH] AMBA DMA: Add a driver module for the DMA controller.

10. DMA Engine vs. DMA Transfer API

11. C6x DMA: using dma_int0 to trigger a dma transaction on dma1

12. ceddk DMA functions (DMA abstraction)

13. Hard Drive Showing as Ultra DMA Mode 3 instead of Ultra DMA Mode 4

14. ICH5 controller and DMA [Was: no DMA for me?]

15. DMA mapping (was [PATCH] cciss 2.6; replaces DMA masks with kernel defines)