Macro for updating all sheet formats in a folder?

Macro for updating all sheet formats in a folder?

Post by John Layn » Mon, 12 Dec 2005 09:07:09


Is there a Macro to update the sheet format for all drawings / sheet in
a folder?

John Layne
www.solidengineering.co.nz
 
 
 

Macro for updating all sheet formats in a folder?

Post by John Layn » Wed, 14 Dec 2005 12:37:28


I was so hoping there would be one out there somewhere. Looks like I
have a lot of mouse clicking to do.

John Layne
www.solidengineering.co.nz

 
 
 

Macro for updating all sheet formats in a folder?

Post by John Layn » Wed, 14 Dec 2005 12:37:28


I was so hoping there would be one out there somewhere. Looks like I
have a lot of mouse clicking to do.

John Layne
www.solidengineering.co.nz
 
 
 

Macro for updating all sheet formats in a folder?

Post by Devon T. S » Wed, 14 Dec 2005 13:36:23

Hello John-

Try using the Task Scheduler to change the format of all drawings in a
folder. It's been a couple of years, but you can run a Macro from the Task
Scheduler. Try recording a Macro, then edit. Look in the help file in Task
Scheduler.

Best Regards,
Devon T. Sowell
www.3-ddesignsolutions.com
"John Layne" <JohnDON' XXXX@XXXXX.COM > wrote in
 
 
 

Macro for updating all sheet formats in a folder?

Post by Devon T. S » Wed, 14 Dec 2005 13:36:23

Hello John-

Try using the Task Scheduler to change the format of all drawings in a
folder. It's been a couple of years, but you can run a Macro from the Task
Scheduler. Try recording a Macro, then edit. Look in the help file in Task
Scheduler.

Best Regards,
Devon T. Sowell
www.3-ddesignsolutions.com
"John Layne" <JohnDON' XXXX@XXXXX.COM > wrote in
 
 
 

Macro for updating all sheet formats in a folder?

Post by Markku Leh » Thu, 15 Dec 2005 03:25:53


any help:
http://www.yqcomputer.com/

that should be quite easy to extend to handle folders...I can check that
out some day.

--

regards

Markku Lehtola

www.markkulehtola.net
 
 
 

Macro for updating all sheet formats in a folder?

Post by John Layn » Sat, 17 Dec 2005 18:19:09


Thank you Gentlemen,

I have delayed the mouse clicking for the time being, I'll try to
combine both your suggestions.

John Layne
www.solidengineering.co.nz