Jon Banquer saddles up again for the long ride on "HORSE'S ASS REVIEW BLOG"

Jon Banquer saddles up again for the long ride on "HORSE'S ASS REVIEW BLOG"

Post by CarCrazy66 » Tue, 13 May 2008 08:14:45


"I say what you said and I'll say what you mean'

Jon Banquer
San Diego, CA

___________


"I'll only say if you said it first'

Jon Banquer
San Diego, CA

____________

"If I say it you can be sure someone else wrote it"

Jon Banquer
San Diego, CA

___________


"Solidworks needs to work on the CAM side of the software"

Jon Banquer
San Diego, CA

___________


"I knew I was right when someone said they use parasolid and could
copy it "

Jon Banquer
San Diego, CA

___________

"I've always said if it was worth saying someone else would of said
it"

Jon Banquer
San Diego, CA

___________


"Solidworks should work on the UV more and not worry about the
wireframe"

Jon Banquer
San Diego, CA

___________
 
 
 

1. Jon Banquer takes it up the ass again with anything shiny.

2. The Jon Banquer Blog Will Cover Siemens NX

NX is arguably one of the most powerful CADCAM programs in the world.
I recently had a non-canned demo of NX done by someone who flew in to
demonstrate what I wanted to see. NX is so powerful and so advanced
that after hours only a very small part of what this program can do
had been shown. The unfortunate part of a program being this powerful
is that no one, including Siemens, has ever been able to properly
describe to a Gibbscam, Mastercam, Featurecam, Surfcam, etc. users
what NX can really do in detail and why NX is so much better and so
much more advanced.

In the coming months the Jon Banquer blog will again break new ground
and attempt to do what no one so far has ever been able to do... show
how the power of NX can make a major difference in shops that are
currently using the products I mentioned above.

Shops that are similar to ours, like Apple's prototype shop, have used
NX for years. There is a reason why and I'll do my best to explain
why.

Jon Banquer
San Diego, CA
http://www.yqcomputer.com/

3. For Those Who Rely On The Jon Banquer Blog...

4. Go Daddy Seeking To Host Jon Banquer's New Blog?

5. The Jon Banquer Blog Finally Covers Discount CAD And CAM

6. A: Liars_Blog Q: What is the Jon Banquer Blog AKA?

7. Third Jon Banquer Blog Setup

8. Coming This Weekend To The Jon Banquer Blog

9. New This Weekend On The Jon Banquer Blog

10. The Jackass Blog with The Babble of Jon Banquer

11. If You're Not Reading The Jon Banquer Blog...

12. The Jackass Blog with The Babble of Jon Banquer

13. What's The Best Way To Read The Jon Banquer Blog?

14. A: Liars_Blog Q: What is the Jon Banquer Blog AKA?

15. If You're Not Reading Jon Banquer Blog You're a wise guy