Error by CAPI-configuration for voice phoning

Error by CAPI-configuration for voice phoning

Post by Wesle » Fri, 21 Jul 2006 23:01:39


Hi together,

for an application I will integrate a voice-phone modul.
The used configuration for CAPI is B1=1, B2=1 and B3=0.

The CAPI_PUT_MSG-function returns no error and a call is going out. But
after some seconds disconnect CAPI and returns the error 34B9: "Bearer
capability not authorized".

For the test I have call my handy and I have see on the monitor (it
flickers), that the call receives by the handy, but it does not ring.

Where can I looking for the error?
Many thanks in above for some help!

Wes
 
 
 

Error by CAPI-configuration for voice phoning

Post by Tobias Eri » Sat, 22 Jul 2006 00:11:09


"Wesley" < XXXX@XXXXX.COM > schrieb im Newsbeitrag


The b-channel-config is not the only thing that is important, but rather the
CIP-value, because this is mapped to a BC & LLC on the network.
If you select bittransparent as protocol, but don't specify "telephony"
for CIP, the other side might not support the call, since it can't accept
calls for "unrestricted digital information"...

Best regards,
Tobias

 
 
 

Error by CAPI-configuration for voice phoning

Post by Wesle » Sat, 22 Jul 2006 00:34:29


Tobias Erichsen schrieb:


That's right - this was the error. Now it works corecctly.
Many Thanks!
Wes