turned off DHCP in Netgear RT314; how to turn back on?

turned off DHCP in Netgear RT314; how to turn back on?

Post by Joe Blo » Sat, 31 Dec 2005 16:04:25


I have a Netgear RT314 Gateway Router. Because of a previous network
setup, I turned off DHCP in this router. Now I can't figure out how to
turn it back on. My PC now has a public IP assigned by the ISP's DCHP
server, not an IP of the 192.168.x.x variety, so I can't telnet or browse
to 192.168.0.1. If I connect the ethernet from the cable modem to the
"Internet" port of the router, I cannot connect to the outside world. I
have to connect the router as a simple switch just to use the internet.
I tried to connect a serial cable method from PC to router and use
hyperterminal, but had no luck. (I have never used the serial com ports on
this PC before so I have no idea if they work or not).
Is there any other method to get the DHCP turned back on? Any way
to get it back to factory defaults?




diagram of current setup
|
cable modem ----------| |"Internet" port
| ____|_____
| | RT314 |
| |__________|
| | | | |
-----------| PC ------PC
 
 
 

turned off DHCP in Netgear RT314; how to turn back on?

Post by William P. » Sat, 31 Dec 2005 22:43:51


Or start here http://www.yqcomputer.com/
wander over to http://www.yqcomputer.com/

Or goto WalMart and get a Linksys router. 8*)

 
 
 

turned off DHCP in Netgear RT314; how to turn back on?

Post by Rich Seife » Sun, 01 Jan 2006 01:45:45

In article < XXXX@XXXXX.COM >,



Try manually assigning an IP address to your PC in the 192.168.x.x
range, which will then allow you to access the router's management
functions and re-enable the DHCP server.


Send replies to: usenet at richseifert dot com
 
 
 

turned off DHCP in Netgear RT314; how to turn back on?

Post by Joe Blo » Sun, 01 Jan 2006 04:08:43

Great idea. That did the trick. Thanks.

Rich Seifert < XXXX@XXXXX.COM > wrote in