Developer Forum

hey guys, i have a topology which looks thusly:

Router
/ \
/ \
\ /
\ /
Router

both paths are tunnels, I would like to load balance between these two
cisco 3550 catalysts with ip routing enabled, so that not only will it
load balance but it will do so intelligently, it will distribute
packets according to load on bandwidth and so on. I am aware that i
could use variance to allow a worse connection to help in load balance
but i would prefer if the load were balanced so that the proportions
are calculated and possibly dynamic. Is this possible and if so what
are the commands necessary?

XXXX@XXXXX.COM ha escrito:


Did you visit this site?
http://www.yqcomputer.com/
Be aware about routers process load in case you chose the best traffic
balance, which is on packet basis.

Good luck