Poblem in Installing sample driver given in DDK sample

Poblem in Installing sample driver given in DDK sample

Post by U2ltcHlfQ » Wed, 26 Apr 2006 14:20:01


I m facing problem in installing sample driver perm2dll.dll and perm2.sys
which are given in DDK samples. When I install these with inf message comes
"This device cannot start. (Code 10)"
Can any one tell why this is happening.
 
 
 

Poblem in Installing sample driver given in DDK sample

Post by UGF2ZWwgQS » Wed, 26 Apr 2006 18:23:02


Perhaps you can do this yourself. Code 10 means that the driver
has been loaded and failed while running.
So you can connect a de *** and track these drivers...

Regards,
--PA

 
 
 

Poblem in Installing sample driver given in DDK sample

Post by Gary G. Li » Thu, 27 Apr 2006 05:14:59

Much of the point of the samples in the DDK is to give you a sandbox in
which to play. You have the source so build a checked build, install it,
connect WinDbg, debug the problem, and then come back here and give us a bit
more information than "it's broke, can anyone tell me why?"

--
The personal opinion of
Gary G. Little