HELP ON PACKAGING

HELP ON PACKAGING

Post by 9193821182 » Wed, 01 Aug 2007 18:40:04


Am new to LABVIEW. I need some vast help on packaging.
 
I attached some blocks in my application. In the whole application, in those two areas only picture setup were there.
 
The problem is VI file is running perfectly but when i build an exe file and running it the pictures didn't get displayed.
 
Please give ur valuable suggestions.
 
Earlier reply was much appreciated.
 
Regards,
Mathan


Doc14.doc:
http://www.yqcomputer.com/
 
 
 

HELP ON PACKAGING

Post by Dereklogit » Wed, 01 Aug 2007 19:40:04

I tend to ask more questions on here than i answer.... but here goes....
 
Is there not something about relative paths and having to strip an additional level when the VI is running as an executable?
 
Think this thread will help.
 
<a href=" http://www.yqcomputer.com/ ;message.id=93323&query.id=128427#M93323" target="_blank"> http://www.yqcomputer.com/ ;message.id=93323&query.id=128427#M93323</a>
 
Derek