Developer Forum

by **gaikwadr** » Wed, 28 Mar 2007 18:10:08

Dear Sir,
We have some vis were made in Labview 7.1 and i want convert them or open them in Labview 8.20, but while i am trying to open them in Labview 8.20 it gives error message "VI Ver(7.1) can't be converted to labview ver(8.20) cause it has no block dia". Detailed error has attached with mail and that vi do not open. So i kindly request you to go through matter and suggest the solution at earliest.
Thanks & Regards
Rajendra GaikwadL & T, Powai.Mo. 09323129933
emailid- <a href="mailto: XXXX@XXXXX.COM " target="_blank"> XXXX@XXXXX.COM </a>

error message.gif:
http://www.yqcomputer.com/

by **gaikwadr** » Wed, 28 Mar 2007 19:10:11

Dear sir,
Actually these vis were made earlier in Labview 7.1 by one of the our vendor. Now we want to use that vis for similar application in Labview 8.20. is there any other option please tell.
Thanks & Regards
Rajendra Gaikwad

by **gaikwadr** » Wed, 28 Mar 2007 19:40:08

Dear Daniel,

It may not be possible to take vis from him in Labview 8.20, except that is there any other solution for that.
I hv one more issue i.e. activation of Labview 8.20. We have purchased Labview 8.0 Devlopment suite from NI, after that now they have sent us updated version Labview 8.20. Can i install and activate the Labview 8.20 on another pc where Labview 8.0 is not installed? also NI has not provided serial no for Labview 8.20. please tell me the how to install and activate labview 8.20.

Thanks & Regards

Rajendra Gaikwad

by **gaikwadr** » Thu, 29 Mar 2007 19:40:07

Dear Daniel
I opened those Labview 7.1 vis in Labview 7.1, now i want to use and modify that vi. please tell me How can i use VI with diagram removed.
Is there any procedure to call block diagram of those vis which block diagram has been removed?
Regards,Daniel