Board index labview

LabVIEW 6.1 crashes, cannot find reference to similar befo:7.1 too drawmgr2.cpp(333

LabVIEW 6.1 crashes, cannot find reference to similar befo:7.1 too drawmgr2.cpp(333

Post by AESulze » Fri, 26 May 2006 04:40:08


This particular error code is really a generic one, so it can be brought about by different causes. The error reported by xband is actually caused by a different bug than the one reported by the original user that started this post, so that explains why it has now popped up again in LabVIEW 7.1. I did do some investigation on our side, though, and it appears as though the bug causing this error in LabVIEW 7.1 has also been fixed in the following (and latest) release of LabVIEW (8.0). If you experience this error again in LabVIEW 8.0, then please follow the instructions for submitting the error log to NI, so that we can investigate the problem.
Kind Regards,
 
 
 
Top

1. I am trying to use a labview program written on labview 6.1 on labview 7.1.

2. Why cannot a VI be run in LabView version 7.1, if it ran in version 6.1?

I developed a VI in LabView 6.1 and try to open it in version 7.1. The
error was as follows "Compile Error - Report this error to NI Tech
Support: nmx unbundler bad sea/eea or edisp-sdisp = 0x1"

It was suggested to me that I should mass compile all my 6.1 files,
before opening them in version 7.1.
I did so and then the error became "Code could not be generated
correctly for this VI / An error occurred in compiling this VI"

Please advise of a potential solution.

Regards,
Raluca C.

3. ActiveX error -2147023149 in LabVIEW 7.1 but not LabVIEW 6.1

4. Can I run a LabVIEW 7.1 Application on a system with LabVIEW 6.1?

5. Problem of Using LabView 7.1 to open LabView 6.1 File

6. Can Labview 6.1 vis be run in Labview 7.1?

7. How can I call a canned visual basic program from LabVIEW 6.1 and 7.1

8. Can I install and run Labview 7.1, 6.1 and 6.02 on the same PC?

9. [Installation] Labview 6.1 or 7.1 setup hangs on NT4sp6

10. Is ther a patch to allow using Vision Builder 6.1 with LabView 7.1?

11. Upgrading from LabVIEW 6.1 to 7.1, get a MS C++ Runtime Error

12. Labview 7.1 to 6.1 conversion

13. porting labview 6.1 to 7.1

14. Using Labview 7.1 code on 6.1

15. FP default-values and diagram "constants" can change in LabVIEW 6.1 and 7.1

All times are UTC
Board index