Can you use zlib from Matlab, only using native Matlab code?

Can you use zlib from Matlab, only using native Matlab code?

Post by Thomas Dic » Thu, 07 May 2009 04:11:01


Hello,

I'm trying to decompress a file using zlib, for use by my Matlab function. Currently I'm doing it by calling Python midway through my function, but I would like to make it so that I don't need to have Python installed on whatever computer I'm trying to run my function on.

I was wondering if there was a way for me to use zlib just using native Matlab code. I don't know much about compression/decompression, so I'm open to any suggestions. I've been searching around for a while, and haven't found anything.

Thanks very much
 
 
 

Can you use zlib from Matlab, only using native Matlab code?

Post by Thomas Dic » Thu, 07 May 2009 04:24:01

Hello,

I'm trying to decompress a file using zlib, for use by my Matlab function. Currently I'm doing it by calling Python midway through my function, but I would like to make it so that I don't need to have Python installed on whatever computer I'm trying to run my function on.

I was wondering if there was a way for me to use zlib just using native Matlab code. I don't know much about compression/decompression, so I'm open to any suggestions. I've been searching around for a while, and haven't found anything.

Thanks very much

 
 
 

Can you use zlib from Matlab, only using native Matlab code?

Post by Ashish Uth » Sat, 09 May 2009 04:18:42

On Tue, 05 May 2009 15:24:01 -0400, Thomas *** inson




You cuold try GUNZIP, which the doc says 'uncompresses GNU zip files', not
sure if this is the same as zlib though.
 
 
 

Can you use zlib from Matlab, only using native Matlab code?

Post by Pete » Sat, 09 May 2009 07:57:45

On May 5, 12:24m, "Thomas *** inson" < XXXX@XXXXX.COM >

> 'm trying to decompress a file using zlib, for use by my Matlab function. Currently I'm doing it by calling Python midway through my function, but I would like to make it so that I don't need to have Python installed on whatever computer I'm trying to run my function on. >> >> I was wondering if there was a way for me to use zlib just using native Matlab code. I don't know much about compression/decompression, so I'm open to any suggestions. I've been searching around for a while, and haven't found anything.> >> > Thanks very much

Check out http://www.yqcomputer.com/

--Peter